This quarter-round tile profile from Genesis' EAQ series has a classic quarter-round visible side and protects the edge of ceramic tiles or a comparable hard surface in wall and floor applications. This version is intended for a tile thickness of 12 mm, has a length of 2.7 metres and is finished in matte silver.
Product & function
The profile is extruded from AA 6063 T6 aluminium and this version is anodised according to DIN 17611. For outdoor applications, Genesis recommends a powder-coated finish.
Application & compatibility
The profile is intended for wall and floor tiles. Choose the version that matches the thickness of your tile, so that the top of the profile is flush with the tile surface. Matching in matte silver and 12 mm, the outside corner piece is EAC120.81. This allows you to finish the corner without mitring. Genesis makes EAC outside corners and EIQ inside corners for this series in 8, 10 and 12 mm.
Use & points of attention
- Choose the profile that matches the thickness of the tile.
- Apply tile adhesive over the area forming the edge of the tilework.
- Press the perforated mounting flange into the adhesive and align the profile. Secure mechanically if necessary.
- Apply additional adhesive over the flange so that it is fully embedded.
- Bed the tiles firmly. The tile surface should be flush with the top of the profile: the profile should not be higher than the tile, but approximately 1 mm lower.
- Fill the joint completely.
Aluminium is sensitive to alkalis. Cement-based materials become alkaline in combination with moisture, so remove adhesive and grout residues immediately from visible surfaces and ensure that the profile is fully embedded, without cavities in which alkaline water can remain. The surface is sensitive to scratches and wear and can be damaged by tile adhesive, mortar or grout. In the event of chemical or mechanical stress, first check whether aluminium is suitable for the situation. Special maintenance is not required. An oxidative film can be removed with a common polishing agent, but will return. A damaged anodised finish can only be repaired by recoating.
Key features
- Classic quarter-round visible side
- Extruded aluminium, AA 6063 T6 alloy
- 30 mm perforated flange for embedding in the tile adhesive
- Matching Genesis corner piece in this colour and thickness
Technical specifications
| Item number |
EAQ127.81 |
| Brand and series |
Genesis EAQ |
| Profile shape |
Quarter-round profile |
| Material |
Aluminium AA 6063 T6 / UNS A96063 |
| Colour |
Matte silver |
| Treatment |
Anodised (DIN 17611) |
| Suitable for tile thickness |
12 mm |
| Length |
2.7 m |
| Wall thickness |
1 mm |
| Mounting flange width |
30 mm |
| Matching outside corner piece |
EAC120.81 |
Frequently asked questions
Which profile thickness do I need? The thickness of the profile follows the thickness of your tile. This version is for 12 mm tiles; the profile must not protrude above the tile surface.
How do I prevent damage from adhesive or grout? Wipe adhesive and grout residues off the profile immediately, as long as they have not yet hardened. Cement-based residues become alkaline with moisture and can damage the aluminium and the finish.
How deep should the profile be in the adhesive? The mounting flange should be fully embedded. After pressing, apply another layer of adhesive over the flange so that no cavities are left behind.
How do I finish a corner? With the EAC120.81 outside corner piece, you finish the corner without mitring. Without a corner piece, you saw the profile at a 45-degree miter.