This square contour profile from Genesis' TDG series is an alternative to a standard straight profile and gives the tile edge a more luxurious finish. The profile has a square appearance, with a slightly bevelled edge for a smooth transition. It can be used vertically along wall tiles, horizontally along floor tiles, or as a decorative strip within the tiled area. This version is designed for 10 mm thick tiles, has a length of 2.5 metres and is finished in bright silver.
Product & function
The profile is extruded from AA 6063 T6 aluminium and this version is anodised in accordance with DIN 17611. The wall thickness is 1 mm and the perforated mounting flange is 18 mm wide. For outdoor use, Genesis recommends a powder-coated finish; this anodised version is therefore intended for indoor use.
Application & compatibility
The profile is designed as an edge trim for wall and floor tiles and as a decorative strip. Choose the version that matches the thickness of your tiles, so that the top of the profile is flush with the tile surface or slightly lower. The matching Genesis corner piece is Corner Piece Bright Silver 10 mm (4 pieces) ECG100.91. This allows you to finish the corner without sharp edges and without cutting a miter joint.
Use & key points
- Choose the profile that matches the thickness of your tiles.
- Apply tile adhesive over the area forming the edge of the tiled surface.
- Press the perforated mounting flange into the adhesive and align the profile. Secure mechanically if necessary.
- Apply additional adhesive over the flange so that it is fully embedded.
- Bed the tiles firmly. The profile must not sit higher than the tile surface, but may sit up to approximately 1 mm lower.
- Fill the joint between the tile and the profile completely with grout.
Aluminium is sensitive to alkaline substances. Cement-based materials become alkaline when combined with moisture; therefore, remove adhesive and grout residues immediately from visible surfaces and ensure that the profile is fully embedded and all cavities are filled, so that no alkaline water can collect. If you expect chemical exposure, test first whether aluminium is suitable. The anodised layer maintains a uniform appearance under normal use, but is sensitive to scratches and wear. Special maintenance is not required. An oxide film can be removed with a standard polishing agent, but will return. A damaged anodised finish can only be repaired by re-coating.
Key features
- Square visible surface with a slightly bevelled edge
- Extruded aluminium, anodised in accordance with DIN 17611
- Suitable for use as an edge trim and as a decorative strip
- Matching ECG corner piece, no miter joint required
Technical specifications
| Item number |
TDG104.91 |
| Brand and series |
Genesis TDG |
| Profile shape |
Square contour profile with a slightly bevelled edge |
| Material |
Aluminium AA 6063 T6 / UNS A96063 |
| Colour |
Bright silver |
| Treatment |
Anodised in accordance with DIN 17611 |
| Suitable tile thickness |
10 mm |
| Length |
2.5 m |
| Wall thickness |
1 mm |
| Mounting flange width |
18 mm |
| Matching corner piece |
ECG100.91 |
Frequently asked questions
Which profile thickness do I need? The thickness of the profile matches the thickness of your tiles. This version is for 10 mm tiles; the profile must not protrude above the tile surface, but may sit up to approximately 1 mm lower.
What is the difference with the TDP profile? Both Genesis profiles provide a square edge. The TDG contour profile also has a slightly bevelled edge for a softer transition to the tile.
How do I prevent damage from adhesive or grout? Wipe adhesive and grout residues off the profile immediately, while they are still wet. Cement-based residues become alkaline when combined with moisture and can damage the aluminium and the finish.
How do I finish a corner? With the Genesis corner piece ECG100.91, you can finish the corner without sharp edges and without cutting a miter joint. Without a corner piece, cut the profile at a 45-degree miter joint.
